Local administrative options
60 SIP Deskphones Release 6.4 Installation and Maintenance Guide
!
WARNING:
WARNING: The SIP call settings entered through the CRAFT menu take precedence over
other sources for this data, for example- 46xxsettings.txt, or PPM. The only way
to override these settings is to go into the CRAFT menu and remove the settings
or perform a “Clear” of the deskphone from the CRAFT menu.
4. The deskphone displays the Global Settings screen and prompts you to use the Right and
Left navigation arrows or a text entry to change a setting and displays the following settings
and their active values:
5. If you selected SIP Proxy Server, the deskphone displays the message "Select SIP proxy
to configure" and displays a list of currently configured servers.
6. To add a new server, press New and enter the address of SIP Proxy. Then, enter values for
the Transport Type and SIP Port as indicated below under changing a setting in Step 6. To
change information for a configured server, select the proxy server for which you want to
update the Transport Type and/or the SIP Port and press Select or OK.
Setting Description/Example Changes this
Configuration Parameter
SIP Domain:
Avaya Environment:
Reg Policy:
Failback Policy:
Avaya Config
Server:
Host to ping
e.g., avaya.com
Auto or No - indicates whether
only an Avaya environment (CM
and Session Manager) is in
effect.
alternate or simultaneous
admin or auto
IP Address of Avaya
configuration server - only if
PPM is not on the same server
as the SIP Proxy server.
IP Address or DNS Name of
server to ping. This is not a
setting but a determiner of
whether a specific server is
reachable. Press the Ping
softkey to initiate the check. The
deskphone sends four pings
and displays the results in a text
block screen. If the ping fails,
the message "Unable to contact
host" displays.
SIP_DOMAIN
DISCOVER_AVAYA_
ENVIRONMENT
SIPREGPROXYPOLICY
FAILBACK_POLICY
CONFIGURATION_SERVER
or
CONFIGURATION_SERVER
_IN_USE
N/A
To Next Page
Loading...
