TLV impact on system parameter values
System parameter
name
TLV name Impact
PHY2VLAN IEEE 802.1 Port
VLAN ID
The value is changed to the Port VLAN identifier in the TLV.
L2QVLAN and L2Q IEEE 802.1 VLAN
Name
The value is changed to the TLV VLAN Identifier. L2Q is set to 1
(ON).
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the parameters
L2Q or L2QVLAN.
VLAN Name TLV is ignored if:
• The value of USE_DHCPis "0" and the value of IPADD is not
"0.0.0.0".
• The current value of L2QVLAN was set by a TIA LLDP MED
Network Policy TLV.
• The VLAN name in the TLV does not contain the substring
"voice" in lower-case, upper-case or mixed-case ASCII
characters anywhere in the VLAN name.
L2Q, L2QVLAN,
L2QAUD,
DSCPAUD,
TIA LLDP MED
Network Policy
(Voice) TLV
L2Q - set to "2" (off) if T (the Tagged Flag) is set to 0 and to "1"
(on) if T is set to 1.
L2QVLAN - Set to the VLAN ID in the TLV.
L2QAUD - Set to the Layer 2 Priority value in the TLV.
DSCPAUD - Set to the DSCP value in the TLV.
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the parameters
L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is "0" and the value of IPADD is not
"0.0.0.0".
• The Application Type is not 1 (Voice) or 2 (Voice Signaling).
• The Unknown Policy Flag (U) is set to 1.
VLAN_IN_USE,
L2QSIG, DSCPSIG
TIA LLDP MED
Network Policy
(Voice Signaling)
VLAN_IN_USE - set to the VLAN ID in the TLV.
If the Layer 2 Priority value in the TLV is not zero, and if the
Application Type is 2 (Voice Signaling), L2QSIG is set to the
Layer 2 Priority value in the TLV.
If the DSCP value in the TLV is not zero, and if the Application
Type is 2 (Voice Signaling), DSCPSIG is set to the DSCP value
in the TLV.
Table continues…
TLV impact on system parameter values
August 2015 Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP Deskphones SIP 69
Comments on this document? infodev@avaya.com
To Next Page
Loading...
