Figure 6: Dongle installed on the server.
To install the software feature dongle
1. Ensure that there is nothing plugged into the upper USB port labeled D on the rear
panel.
2. If the software feature key is not pre-installed in the dongle, insert it into the software
feature slot on the dongle. Insert the software feature key with the data contact
facing down and away from the embossed i. See
Figure 8: Installing the feature
key on page 37.
Figure 7: Dongle without feature key
3. To eject a software feature key, insert a straightened paper clip into the side access
hole.
Push the paper clip in the direction of the software feature key.
Installing the server and peripheral devices
36 Avaya CallPilot® 1006r Server Hardware Installation December 2010
To Next Page
Loading...
