Chapter 3: Installation
Installation checklist
Use the following checklist to complete the installation of the server.
No. Task Description Notes
1 Discharge electrostatic energy. See Electrostatic discharge on
page 20.
2 Inspect package contents. See Package contents on
page 21.
3 Install the server using the rail kit. See Installing the server on
page 22.
4 Attach cables. See Attaching cables on
page 26.
5 Connect power. See Connecting power on
page 27.
The following items are application-specific. Refer to the application-specific documentation for
additional information on:
• Initial configuration and IP address assignment.
• Ethernet port cabling.
• Application shutdown procedures.
Electrostatic discharge
Electrostatic discharge (ESD) is a discharge of stored static electricity that can damage equipment
and impair electrical circuitry. Electrostatic voltages can result from friction including, pulling
cabling through conduits, walking across carpeted areas, and building static charge in clothing.
When you improperly handle electronic components, ESD damage occurs and can result in
complete or intermittent failures. While networking equipment is commonly designed and tested to
withstand common mode ESD events, voltage can sometimes discharge to some connector pins,
which can potentially damage the networking equipment.
October 2019 Installing the Avaya Converged Platform 130 Series 20
Comments on this document? infodev@avaya.com
To Next Page
Loading...
