5. Perform the following actions to install the system in the rack:
Task order Task
1 Pull the inner slide rails out of the rack until they lock into place.
2 Locate the rear rail standoff on each side of the system and lower them into the
rear J-slots on the slide assemblies.
3 Rotate the system downward until all the rail standoffs are seated in the J-slots.
4 Push the system inward until the lock levers click into place. Press the slide-
release lock buttons on both rails and slide the system into the rack
Attaching cables
About this task
Use this procedure to attach network and I/O cables to the system.
Installation
October 2019 Installing the Avaya Converged Platform 130 Series 26
Comments on this document? infodev@avaya.com
To Next Page
Loading...
