5. In the Change autostart configuration window, set the autostart configuration as follows:
a. In the Enabled field, select Yes.
b. In the Start delay field, type 120.
c. In the Stop delay field, type 120.
d. In the Stop action field, click Shut down.
e. In the Wait for heartbeat field, select no.
6. Click Save.
7. Click the right mouse button on the host name, and click Reboot to restart the server.
Next steps
After the server has restarted, verify that all VMs are powered on and are correctly configured.
Configuring SNMP v2 on an ESXi 6.5 host
About this task
The SNMP configuration can report ESXi related traps and alarms to multiple trap receivers. The
SNMP v2 setting is available on ESXi. This section provides steps on configuring SNMP v2.
Note:
The SSH functionality must be enabled on ESXi. The Avaya installation guidelines direct
administrators to enable SSH, so this should not be an issue. If, however, ESXi shell is not
enabled, refer to steps 14 and 15 above under the “Steps for Configuring ESXi Network
Settings” section to enable ESXi shell and SSH.
Configuration
October 2019 Installing the Avaya Converged Platform 130 Series 44
Comments on this document? infodev@avaya.com
To Next Page
Loading...
