Avaya Converged Platform 130 Series - Page 45

Procedure
1. From a Putty session, via SSH, access the ESXI host.
2. Type the following command to set the community string to be exchanged between the
ESXi host and the trap receiver(s):
esxcli system snmp set -–communities <community string>
3. Administer the trap receivers:
esxcli system snmp set –targets <SAL_GW_IP_ADDRESS>@<port#>/<community>
Example with multiple targets, separated by a comma:
esxcli system snmp set –targets 10.1.1.1@162/avaya123,10.1.1.2@162/avaya123
4. Enable SNMP on the host using the following command:
esxcli system snmp set --enable true
Dell R640 XL ESXi Configuration
October 2019 Installing the Avaya Converged Platform 130 Series 45
Comments on this document? infodev@avaya.com