Procedure
1. Navigate to Configuration > System settings > Alert Configuration.
2. In the Alerts field, click Enabled.
3. In the Alerts and Remote System Log Configuration section, in the SNMP Trap column,
select the required SNMP trap check boxes.
For Avaya SAL systems, select the check box in the heading row of SNMP Trap column to
select all the available SNMP traps.
4. Click Apply.
Configuring a user account for SNMP v3 traps
About this task
To configure an SNMP v3 traps, you must associate a user account with the traps. The password
of this user account is used to encrypt the SNMP v3 traps. The same password must be used by
the SNMP v3 trap receiver to decrypt trap information.
Before you begin
Log into the iDRAC9 web interface using the IP address and login details that were specified while
configuring iDRAC. See Avaya iDRAC9 Best Practices document for configuring the iDRAC.
Configuration
October 2019 Installing the Avaya Converged Platform 130 Series 78
Comments on this document? infodev@avaya.com
To Next Page
Loading...
