Procedure
1. Navigate to iDRAC Settings > Users.
2. In the Local Users section, select the user that you want to edit for SNMP v3 traps.
3. Click Edit.
4. On the User Configuration tab, scroll down to the Advanced settings section.
5. In the SNMP v3 field click Enabled.
6. In the Authentication type field, click the required authentication type.
7. In the Privacy type field, click the required privacy type.
8. Click Save.
Dell R640 SNMP trap configuration using iDRAC9
October 2019 Installing the Avaya Converged Platform 130 Series 79
Comments on this document? infodev@avaya.com
To Next Page
Loading...
