Using the CU360 Remote-control
The remote-control provided inside the box is already paired, just plug in the provided batteries.
If the remote-control is not pre-paired with your CU360 codec unit, you need to do the following:
• Assure that the remote-control is equipped with 2 AAA charged batteries.
• Unplug the codec unit from power.
• Press the Back key and the OK key together, until the small blue LED on top of the remote
quickly flashes a few times.
• While the LED light is still flashing, plug the codec unit into power while keeping the
remote-control close to the unit. The remote-control led should stop flashing to show
successful pair.
• If the pairing fails, assure to disconnect all the cables from the codec unit, including USB.
Figure 8: Remote-control Keys
To Next Page
Loading...
