Auto Framing (i.e. Group Framing)
When the Camera Tracking is active, and the current mode for the CU360 app is Auto Framing,
the camera is automatically pan/tilt/zoomed to include all the people present in the room (based
on face detection) inside the best possible frame.
If the people in the room change their relative positions, or enter/exit the room, the frame is
automatically adjusted to include all the present people (identified by their faces), with the best
pan/tilt/zoom positioning for a Group Framing.
• Important
• Only faces in front of the camera are detected.
o Check that the room is properly lighted.
o Check that the room does not contain mirrors or other highly reflecting
surfaces, or pictures on the walls depicting faces.
o Assure that the distance of the people from the camera is not more that 3.0-
3.5 meters, and that the faces are towards the camera.
o Faces covered by masks could be not detected in this release.
• See Optimal Huddle Room Setup for supported arrangement of the room. Up to 4
different faces can be recognized for Auto Framing.
Figure 5: Auto Framing Disabled vs Enabled, with Four Faces Detected in the Room
Figure 6: Auto Framing Enabled: Faces Populating the Room Enlarge the Frame
Near Camera Presets for CU360 App
A camera preset is an item including:
o A camera selection (for instance HD1 or USB)
To Next Page
Loading...
