Before you begin
• Connect one side of the USB cable to the Avaya Room Camera RC100 USB port and the
other side to the Avaya CU360 USB port.
• Connect the power supply plug to the DC IN 12V port of the Avaya Room Camera RC100
and turn on the Avaya CU360 endpoint.
Procedure
1. Do one of the following:
• On the endpoint main menu, click Configure.
• On the web interface, click Administrator Settings.
2. On the endpoint, click Advanced.
The default PIN for Advanced settings on the endpoint is 1234.
If your administrator configures a PIN to access the advanced settings on the endpoint,
Avaya CU360 prompts you to enter the PIN. After you enter the PIN, Avaya CU360
displays the Advanced window.
3. Click I/O Connections > Cameras > USB.
4. Configure the following fields:
• Enable: Yes
• Control Camera: Yes
5. On the web interface, click Save.
6. Restart the Avaya CU360 endpoint.
Related links
Avaya CU360 supports Avaya Room Camera RC100 on page 31
Configuring Avaya Tracking Camera TC220 as IP camera
for
Avaya CU360
About this task
You can use Avaya Tracking Camera TC220 as an IP camera on Avaya CU360.
Avaya CU360 does not support audio from IP camera.
Initial administration
October 2022 Installing and Administering Avaya Collaboration Unit CU360 104
Comments on this document? infodev@avaya.com
To Next Page
Loading...
