Before you begin
• Connect one end of the ethernet cable to the Avaya Tracking Camera TC220 LAN port
and the other end to the router/switch of your Local Area Network. Connect one end of the
ethernet cable to the router and other end to the Avaya CU360 or connect the Avaya CU360
to the network through Wi-Fi.
• Connect the power supply plug to the DC IN 12V port of the Avaya Tracking Camera TC220
and turn on the Avaya CU360 endpoint.
• Enable the advanced settings for the Avaya CU360 endpoint.
• Log in to the Avaya CU360 web interface.
• Disable the tracking camera option from the Avaya Tracking Camera TC220.
Procedure
1. Do one of the following:
• On the endpoint main menu, click Configure.
• On the web interface, click Administrator Settings.
2. On the endpoint, click Advanced.
The default PIN for Advanced settings on the endpoint is 1234.
If your administrator configures a PIN to access the advanced settings on the endpoint,
Avaya CU360 prompts you to enter the PIN. After you enter the PIN, Avaya CU360
displays the Advanced window.
3. On the endpoint and web interface, click I/O Connections > Cameras > IP.
4. Configure the following fields:
• Enable: Select Yes to enable the IP camera.
• URL: Enter the IP address of the Avaya Tracking Camera TC220.
To view or set the camera IP address using its remote control inside the menu, enter
System > Network (DHCP or Static).
rtsp://[username:password@]camera_ip_address[:port]/filename
Configuring Avaya Tracking Camera TC220 as IP camera for Avaya CU360
October 2022 Installing and Administering Avaya Collaboration Unit CU360 105
Comments on this document? infodev@avaya.com
To Next Page
Loading...
