Avaya CU360 - Page 107

Before you begin
• Connect one end of the HDMI cable to the Avaya Tracking Camera TC220 HDMI port and
the other end to the
Avaya AV Grabber HDMI port.
• Connect one end of the USB cable to the Avaya AV Grabber USB port and the other end to
the Avaya CU360 USB port.
• Connect the power supply plug to the DC IN 12V port of the Avaya Tracking Camera TC220
and turn on the Avaya CU360 endpoint.
• Enable the advanced settings for the Avaya CU360 endpoint.
• Log in to the Avaya CU360 web interface.
Procedure
1. Do one of the following:
• On the endpoint main menu, click Configure.
• On the web interface, click Administrator Settings.
2. On the endpoint, click Advanced.
The default PIN for Advanced settings on the endpoint is 1234.
If your administrator configures a PIN to access the advanced settings on the endpoint,
Avaya CU360 prompts you to enter the PIN. After you enter the PIN, Avaya CU360
displays the Advanced window.
3. On the endpoint and web interface, click I/O Connections > Cameras > USB.
4. Configure the following fields:
• Enable: Yes
• Control Camera: Yes
To digitally control the PTZ option from the Avaya CU360 endpoint through USB, you
need to disable the tracking mode on the Avaya Tracking Camera TC220. Connect the
Avaya Tracking Camera TC220 to an HDMI monitor and using the Avaya Tracking Camera
TC220 remote control, enter System > MoreParam > Tracking > On/Off.
Configuring Avaya Tracking Camera TC220 as USB camera for Avaya CU360
October 2022 Installing and Administering Avaya Collaboration Unit CU360 107
Comments on this document? infodev@avaya.com