Name Description
SIP Preferred IP Signaling The option to define the preferred IP version for
signaling in the SIP-based calls.
You can configure this field only if :
• You enable Use IPv6 to Yes.
• The destination IP address is an FQDN.
The preferred IP version for signaling are:
• Automatic
• IPv4
• IPv6
The default value for JITC Mode is IPv4.
SIP ANAT The option to enable Avaya CU360 to offer
different types of alternative addresses in a Session
Description Protocol as specified in RFC 4091 and
RFC 4092.
You can configure this field only if you enable Use
IPv6 to Yes.
SIP ANAT Preferred IP Media The option to define the preferred IP version order
to use ANAT for declaring media addresses, such
as audio, video, and data.
You can configure this field only if you enable Use
IPv6 to Yes.
The preferred IP version for media are:
• Automatic
• IPv4
• IPv6
The default value for JITC Mode is IPv4.
Configuring LAN for IPv4 address settings in Avaya CU360
About this task
After you save the settings on Avaya CU360 web interface, you must log in to Avaya CU360 web
interface again.
This configuration is available only if your administrator enables the advanced settings for users.
Configuring LAN for IPv4 address settings in Avaya CU360
October 2022 Installing and Administering Avaya Collaboration Unit CU360 149
Comments on this document? infodev@avaya.com
To Next Page
Loading...
