IP section
Name Description
Enable All Addresses The option to allow remote access to Avaya CU360 using AT commands
from all IP addresses or restrict the AT commands access to a specific
range of IP addresses.
The options are:
• Yes: Enables the remote access to Avaya CU360 using AT commands
from any IP address.
• No: Restricts the remote access to Avaya CU360 using AT commands
to a specific range of IP addresses. You can define the range of IP
addresses in
Address and Subnet Mask.
Address The IP addresses of the devices that you allow to send AT command.
You can enter a value in this field only if you configure Enable All
Addresses to No.
Subnet Mask The range of addresses that you allow to send AT command.
You can enter a value in this field only if you configure Enable All
Addresses to No.
SSH section
Name
Description
Enabled The option to enable the AT commands API through SSH.
User Name The user name for the SSH management.
The default user name is Admin.
Password The password for the SSH management.
The default password is 1234.
RS232 Serial Port section
Name
Description
Always Initialized The option to accept an AT initialization command before accepting other
commands, when required by the API.
Use this option when the controlling device cannot detect whether Avaya
CU360 restarted.
Baud Rate The baud rate of the devices that you allow to remotely gain access to
Avaya CU360.
The baud rate must be the same as the baud rate of the controlling
device.
Advance administration
October 2022 Installing and Administering Avaya Collaboration Unit CU360 180
Comments on this document? infodev@avaya.com
To Next Page
Loading...
