Procedure
1. Generate the site certificate from the Avaya network and provide the certificate to the
customer for loading onto
Avaya CU360.
2. Click Administrator Settings > Utilities > Certificates > Enhanced Access Security
Gateway (EASG).
3. Enter the Mandatory Site Authentication Factor (SAF) password.
4. Upload the site certificate.
Avaya CU360 automatically loads the site certificate.
Next steps
Customers can delete the certificate from the Avaya CU360 when the Avaya Service Personnel no
longer require access. Customers can display information about the certificates using Command
Line Interface.
Troubleshooting
October 2022 Installing and Administering Avaya Collaboration Unit CU360 222
Comments on this document? infodev@avaya.com
To Next Page
Loading...
