Avaya CU360 - Web Enhancements

Pairing the remote control unit with Avaya CU360
Before you begin
Insert two AAA batteries in the remote control unit.
Procedure
1. Remove the power cable of Avaya CU360.
2. On the remote control unit, simultaneously press the following two keys until the small blue
LED indicator on
Avaya CU360 flashes:
• Back
• OK
3. When the LED indicator is flashing, insert the power cable plug of Avaya CU360 in the
power socket.
Ensure that the remote control unit is in proximity to Avaya CU360 when you insert the
power cable.
Result
The LED indicator of the remote control unit stops flashing to indicate successful pairing with
Avaya CU360.
Next steps
If the remote control unit pairing fails, remove all cables from Avaya CU360, and repeat the
procedure.
Related links
Avaya CU360 remote control unit on page 16
Logging in to the Avaya CU360 web interface
About this task
The home page of Avaya CU360 displays the IP address of the endpoint on the top.
Change the default login credentials when you log in to the web interface for the first time.
Procedure
1. In a web browser, navigate to the IP adress of Avaya CU360.
Avaya CU360 displays the login page.
2. Enter the following:
• User Name: The default user name is Admin.
• Password: The default password is 1234.
Initial setup and connectivity
October 2022 Installing and Administering Avaya Collaboration Unit CU360 36
Comments on this document? infodev@avaya.com