If your administrator configures a PIN to access the advanced settings on the endpoint,
Avaya CU360 prompts you to enter the PIN. After entering the PIN, Avaya CU360 displays
the Advanced window.
3. Click System > Customization.
Avaya CU360 displays the Customization page.
4. Select USB Bar Mode.
5. Configure the following:
• Manual: Connect the computer to the Avaya CU360 endpoint through a USB cable then
you can activate USB Bar mode through the Avaya CU360 remote control or the Avaya
CU360 web interface.
• Always Active: Connect your computer to the Avaya CU360 endpoint through a USB
cable to start using the
Avaya CU360 audio/video peripherals from your computer.
Result
• Avaya CU360 displays rotating LEDs that become green on the endpoint.
• Avaya CU360 automatically rejects incoming calls and changes to the Do not disturb mode.
• Avaya CU360 silences calendar meeting notifications.
Related links
Avaya USB AV bar on page 30
Activating the USB AV bar mode in Avaya CU360
About this task
Avaya CU360 supports excellent video quality with a maximum resolution of 1080p@30fps when
using as a USB camera.
Tip:
You can press the Camera Control key on the remote control of Avaya CU360 to activate the
USB Bar Mode.
Before you begin
Connect the USB 3.0 cable to the USB-C port of the Avaya CU360 endpoint.
Procedure
1. Do one of the following:
• On the endpoint home page, click Control Camera.
• On the web interface, click More Actions.
2. Click USB Bar Mode.
Initial administration
October 2022 Installing and Administering Avaya Collaboration Unit CU360 98
Comments on this document? infodev@avaya.com
To Next Page
Loading...
