E-DIG-STA (Emulated Digital Line)
Issue 4 May 2002
10-727555-233-123
1004 ABORT The port was seized by a valid call during the test.
1. Use display port PCSSpp to determine the station
extension or attendant number of the port.
2. Use status station or status attendant to determine the
service state of the port. If the service state indicates that
the port is in use, then the port is unavailable for certain
tests.
3. Wait until the port is idle before retesting. Attendants are
always in use (off-hook) if the handset is plugged in and the
port is not busied out.
1020 ABORT Test disabled by background testing. Use the status station
command to determine when the station is available for testing.
2000 ABORT Response to the test request was not received within the
allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1
2
FAIL The Network Processing Element (NPE) of the tested port is
transmitting in error. This causes noisy and unreliable
connections.
Failure code 1 indicates that the Crosstalk test failed on the
primary channel.
Failure code 2 indicates that the Crosstalk test failed on the
secondary channel.
1. Replace the circuit pack.
PASS The port is correctly using its allocated time slots.
1. To ensure that this is not an intermittent problem, repeat
this test a maximum of 10 times.
2. If complaints persist, examine the station, connections, and
wiring.
Table 10-271. TEST #9 Digital Line NPE Crosstalk Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
