Chapter 3: Installing the new streaming and
recording server
Installation checklist
Follow the steps in this checklist to install the Avaya Equinox Streaming and Recording Server
(Equinox Streaming and Recording).
Tip:
It is a good idea to print out this checklist and to mark each task as you complete it.
No. Task Description Notes
1 Learn more about the new
streaming and recording server
and figure out your deployment
type.
Avaya Scopia
®
Streaming and
Recording server on page 8
2 • Connect the LAN cables,
keyboard, mouse, and
monitor for your new server.
• Alternatively, you can
purchase a Microsoft
™
Windows Image (WIM) and
install Equinox Streaming
and Recording on your own
server.
• Physically connecting the new
server on page 26
• For more information about
obtaining and installing the
Equinox Streaming and
Recording WIM, see the
Equinox Streaming and
Recording Disaster Recovery
Guide, which is available from
support.avaya.com.
3 Start up the server. Starting the new server on
page 46
You require the Microsoft
Windows product key.
4 Configure the server using the
Avaya Equinox Streaming and
Recording Server
Configuration Wizard.
Configuring the new server on
page 47
5 Set the IP addresses and
apply the licenses.
Licensing the new server on
page 51
6 Configure the network that
each device will use to
Configuring external addresses
for public interfaces on page 60
Before registering devices,
you may want to set which
Table continues…
August 2017 Installing the Avaya Equinox Streaming and Recording Server 25
Comments on this document? infodev@avaya.com
To Next Page
Loading...
