Avaya IP500 V2 - Restoring from the Backup Folder

IP500/IP500 V2 Installation Page 130
15-601042 Issue 25i (03 January 2013)IP Office 8.0
6.7.2 Using an SD Card
In addition to using the traditional IP Office Upgrade Wizard , IP500 V2 control units can be upgraded by loading the
required set of firmware files onto the System SD card and rebooting the system.
· ! IP Office Technical Bulletins
Ensure that you have obtained and read the IP Office Technical Bulletin relating to the IP Office software release
which you are installing. This bulletin will contain important information that may not have been included in this
manual. IP Office Technical Bulletins are available from the Avaya support website (http://support.avaya.com).
· ! Upgrade Licenses
Some upgrades may require entry of upgrade licenses. It is still possible to upgrade the system without the
necessary licenses, however the system will not provide any telephony functions after the upgrade until the
appropriate license is added to the system configuration.
· ! WARNING
This process will require the IP Office system to reboot in order to complete the process. Any current calls and
services will be ended by the reboot.
There are a number of ways in which this can be done.
Method
Description
Location
Software
Files
Embedded
Voicemail
Prompts
Using Manager
Using IP Office Manager, the contents of the card are
compared to the files that Manager has available and
are upgraded if necessary.
Local or
Remote
System SD Card
Upgrade
In this method, the System SD card is shut down and
removed from the control unit. The card's contents are
upgraded using IP Office Manager.
Local
Upgrade from
Optional SD Card
This method uses an SD card loaded with the required
version of IP Office software. The card is inserted into
the control unit's Option SD card slot and its contents
copied to the System SD card.
Local
–
128
168
168
169