Avaya IP500 V2 - DS Phones

IP500/IP500 V2 Installation Page 134
15-601042 Issue 25i (03 January 2013)IP Office 8.0
6.8.1 DS Phones
When digital phone extensions are required in another building, additional In-Range Out-Of-Building (IROB) protective
equipment must be used. For phones connected to IP Office DS ports, the supported device supplied by ITWLinx is a
towerMAX DS/2 module. This IROB device was previous badged by Avaya as the 146E IROB.
· ! WARNING
This device is not supported for TCM port connections, ie. 4100 Series, T-Series, 7400 Series and M-Series phones.
The protection device should be installed as per the instructions supplied with the device. The ground points on the IP
Office control unit and any external expansion modules must be connected to a protective ground using 18AWG wire with
a green and yellow sleeve.
Typically the IROBs 2 RJ45 EQUIPMENT ports are straight through connected to the 2 RJ45 LINE ports. This allows existing
RJ45 structured cabling, using pins 4 and 5, to be used without rewiring for up to two DS connection. However, each of
these ports can be used to connect a second extension using pins 3 and 6.
LINE
Signal
EQUIPMENT
1
Not used.
1
2
Not used.
2
3
Ring II (Optional)
3
4
Ring I
4
5
Tip I
5
6
Tip II (Optional)
6
7
Not used.
7
8
Not used.
8
381