Avaya IP500 V2 - Example 2: Video Conference; Issue 25 I (03 January

To Next Page

To Previous Page

IP500/IP500 V2 Installation Page 139

15-601042 Issue 25i (03 January 2013)IP Office 8.0

Additional Processes: So8 BRI Module

6.10.2 Example 2: Video Conference

In this example, calls are routed to a Polycom Viewstation module connected to a S0 port of the IP Office system.

The following settings were used on 4 incoming data channels of a PRI line:

· Line Number: 5

· Channel Allocation: 23 -> 1

· Switch Type: 5ESS

· Line Sub Type: PRI

· Provider: AT&T

· Channels: 1-4

· Incoming Line Group: 95

· Outgoing Line Group: 95

· Direction: Bothway

· Bearer: Data

· Service: Accunet (this is a important)

· Admin: In Service

To route an incoming video call on the PRI lines configured above to an SO8 module requires the following:

Create a dial short code that has the SO port as its destination Line Group. For this example the following was used:

Short Code: 1500

Number: .

Feature: Dial

Line Group: 601 (the SO8 port number)

Create an Incoming Call Routing that routes the appropriate calls to that short code. For this example the following was

used:

Line Group: 95 (identifies calls using the PRI lines configured above)

Destination: 1500 (the short code created above)

Bearer: Any

To allow the video device on the S0 port to make outgoing calls to the PRI lines also requires a short code.

For this example the following was used:

· Code: 91N;

· Number: N

· Feature: Dial

· Line Group: 95

Other manuals for Avaya IP500 V2