IP500/IP500 V2 Installation Page 16
15-601042 Issue 25i (03 January 2013)IP Office 8.0
1.2 Control Units
The base of any IP Office system is the system or control unit. It stores the system configuration and controls the system
operation. Each control unit can be customized by adding various base and trunk cards. External expansion
modules can be also be connected to add additional extension and trunk ports.
IP Office Release 8.0 supports the following IP Office control units. Previous IP Office control units are not supported by IP
Office Release 8.0 and are not covered by this documentation.
· IP500v2 Control Unit
This control unit has four front slots for IP500 base cards. It has
an internal power supply unit and uses a mandatory System SD
card Feature Key dongle. It includes a 2 port ethernet LAN switch
(layer 3 managed) on the rear.
· The type of System SD card fitted to the system determines
the operation mode of the system. The possible modes
are:
· IP Office Basic Edition - PARTNER® Mode
· IP Office Basic Edition - Norstar Mode
· IP Office Basic Edition - Quick Mode
· IP Office Essential Edition
For systems to operate in IP Office Essential Edition, its
configuration must include an Essential Edition License.
· IP500 Control Unit
This control unit has four front slots for IP500 base cards. It has
an internal power supply unit and uses a mandatory smart card
Feature Key dongle. It includes a 2 port ethernet LAN switch
(layer 3 managed) on the rear.
21 24
201
11
204
To Next Page
Loading...
