IP500/IP500 V2 Installation Page 22
15-601042 Issue 25i (03 January 2013)IP Office 8.0
IP500 Legacy Card Carrier Base Card
This card allows various IP400 trunk cards and IP400 VCM cards
to be used. The front of the card includes panels that can be removed
to match the trunk card fitted.
· This card does not accept any IP500 trunk daughter card.
· Maximum: 2 per control unit.
· IP400 Cards Supported: The following cards are supported.
PRI T1
Dual PRI T1
PRI 30 E1 (1.4)
Dual PRI E1
PRI 30 E1R2 RJ45
Dual PRI E1R2 RJ45
BRI-8 (UNI)
ANLG 4 Uni (US only)
VCM 4
VCM 8
VCM 16
VCM 24
VCM 30
IP500 4-Port Expansion Base Card
This card adds an additional 4 expansion ports for external expansion modules. The
card is supplied with four 2m yellow interconnect cables.
· This card does not accept any IP500 trunk daughter card.
· Maximum: 1 per control unit (Right-hand slot 4 only).
· Supported Expansion Modules: The following external expansion modules are
supported:
· IP500 Analogue Trunk Module
· IP500 BRI So Module
· IP500 Digital Station Modules
· IP500 Digital Station Modules A
· IP500 Phone Module
· IP400 Digital Station V2 Modules
· IP400 Phone V2 Modules
IP500 BRI Combination Card
This card provides 6 digital station ports (1-6), 2 analog extension ports
(7-8) and 2 BRI trunk ports (9-10, 4 channels). The card also includes
10 voice compression channels.
· This card has a pre-installed IP500 BRI trunk daughter card .
· Maximum: 2 combination cards per IP500 V2 control unit,
regardless of type. Not supported by IP500 control units.
· IP Office Basic Edition - Norstar Mode and IP Office Basic Edition
- Quick Mode systems are limited to a maximum of 12 BRI
channels using BRI Combination and or BRI trunk daughter
cards.
IP500 ATM Combination Card
This card provides 6 digital station ports (1-6), 2 analog extension ports
(7-8) and 4 analog trunk ports (9-12). The card also includes 10 voice
compression channels.
· This card has a pre-installed IP500 analog trunk daughter card .
· Maximum: 2 combination cards per IP500 V2 control unit,
regardless of type. Not supported by IP500 control units.
· The analog phone ports do not include a ringing capacitor. Where
this is a requirement, connection should be via a Master socket
containing ringing capacitors.
· If fitted with an IP500 Analog Trunk daughter card, during power
failure phone port 8 is connected to analog trunk port 12.
218
25 26
210
213
24
212
24
To Next Page
Loading...
