IP500/IP500 V2 Installation Page 223
15-601042 Issue 25i (03 January 2013)IP Office 8.0
System Components: IP500 Trunk Daughter Cards
9.4.1 Analog Trunk Card
This card can be added to an IP500 base card to provide that card with support for 4 loop-start analog trunks.
This card can be fitted to any IP500 base card except the IP500 Legacy Carrier card and IP500 4-Port Expansion card.
· Ports/Channels
4 Loop-start analog trunk ports. Connections via the host IP500 base card.
· DTMF, ICLID, Busy tone detection.
· Over-voltage and lightning protection (may still require additional
protection equipment see Lightning Protection/Out-of-Building
Connections .
· DTMF and LD dialing.
· Adjustable echo cancellation (default 16ms). Selectable to Off, 8, 16, 32,
64 and 128 milliseconds.
· Power Failure Port
Regardless of the IP500 card hosting it, during power failure pins 4 and 5
of port 12 are connected to pins 7 and 8. In addition, when fitted to an
IP500 Analog Phone 8 base card, during power failure extension port 8 is
connected to the analog trunk port 12.
· License: No license required.
· Maximum per Control Unit: 4.
· IP Office Software Level: 4.0+.
New build PCS10 cards are only supported in systems running IP Office
Release 6.1(20), 7.0(12) or 8.0 and higher. Refer to IP Office Technical Tip
237.
Daughter Card Ports (9-12)
The LEDs for ports 9 to 12 of the IP500 base card are used as follows:
· Green on = Card fitted.
· Green flashing = Trunk in use.
· LED 9 is also used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card
okay.
· Red Fast Flash = System shutdown.
IP Office 500 Trunk Card Analog 4 Universal
40
To Next Page
Loading...
