IP500/IP500 V2 Installation Page 230
15-601042 Issue 25i (03 January 2013)IP Office 8.0
9.5.2 BRI SO8
The So8 module can be used to add ETSI BRI S0-interface ports to the IP Office system. These ports can then be used for
the connection of ISDN devices.
IP500 and IP500 V2. The control unit must be running in IP Office Essential Edition. This module is
not supported in IP Office Basic Edition - PARTNER® Mode, IP Office Basic Edition - Norstar Mode or
IP Office Basic Edition - Quick Modes.
Supported in all IP Office locales .
IP Office core software level 1.0 minimum. Bin file = nas0-16.bin.
Power supply unit (see below) and Expansion Interconnect cable.
The unit is supplied with an earthed 3-Pin, 60W external power supply unit. The PSU has an integral
power cord for connection to the unit's DC I/P socket. A locale specific IEC60320 C13 power cord
for the external PSU is required but is not supplied with the unit.
The module is designed as a free-standing module that can be stacked on or under other IP Office
modules. The module can be rack mounted in a 19" rack system using the optional IPO IP500 RACK
MNTG KIT. It can be wall mounted using the IPO IP500 RACK MNTG KIT V2.
Width: 445mm/17.5". Depth: 245mm/9.7". Height: 71mm/2.8"/2U.
Unboxed: 2.8Kg/6.3lbs. Boxed: 4.1Kg/9.2lbs.
48
34
To Next Page
Loading...
