Avaya IP500 V2 - T1 PRI Trunk Cards; E1 PRI Trunk Cards

IP500/IP500 V2 Installation Page 245
15-601042 Issue 25i (03 January 2013)IP Office 8.0
System Components: IP400 Trunk Cards
9.7.4 T1 PRI Trunk Cards
These trunk cards support 23B+D primary rate (US PRI) trunks and 24B T1 robbed-bit trunks. The mode of operation is
selected within the IP Office configuration.
The T1 PRI card includes an integral CSU/DSU that can be activated through the IP Office Monitor application.
PRI Trunk Cards
Country
SAP Code
IP500
IP500
V2
IP400 PRI 24 T1
North America
700185200
IP400 PRI 48 T1
North America
700185218
· These cards include two plastic stand off pillars for installation and a replacement blanking plate for the rear of
IP400 control units.
· For dual port cards the IP406 V2 only supports a single dual card in Slot A.
· For the IP500 and IP500 V2 control units, an IP500 Carrier Card is required, up to a maximum of 2 IP500 Carrier
Cards.
9.7.5 E1 PRI Trunk Cards
These cards support primary rate trunks providing 30B+D channels.
E1 PRI trunk Cards
Country
SAP Code
IP500
IP500
V2
IP400 PRI 30 E1
(1.4)
All except China and
CALA.
700272461
IP400 PRI 60 E1
All except China and
CALA.
700185184
· These cards include two plastic stand off pillars for installation and a replacement blanking plate for the rear of
IP400 control units.
· For dual port cards the IP406 V2 only supports a single dual card in Slot A.
· For the IP500 and IP500 V2 control units, an IP500 Carrier Card is required, up to a maximum of 2 IP500 Carrier
Cards.