IP500/IP500 V2 Installation Page 262
15-601042 Issue 25i (03 January 2013)IP Office 8.0
So8 Module Connections
RJ45 socket. Used for connection of ISDN terminal devices.
Note: These ports appear a lines within the IP Office configuration. However they cannot be used for
connection to external BRI lines.
DC power input port. Used for connection of the power lead from an Avaya 60W external power supply
unit supplied with the expansion module. A locale specific IEC60320 C13 power cord for the external
PSU is required but is not supplied with the module.
25-Way D-Type socket. For Avaya use only.
RJ45 Socket. Used for direct connection to an Expansion port on an IP Office control unit using the
Expansion Interconnect cable supplied with the module.
Function ground point. Used for connection of a protective or functional ground if required. On older
modules where this screw is not present, the top-center cover screw should be used instead.
All expansion modules are supplied with a base software level and should be upgraded to match the core software of the
control unit in the IP Office system. Expansion modules include an external power supply unit (PSU) and an appropriate
interconnect cable. They do not include a locale specific power cord for the external PSU or any phone extension cables.
379
381
34
146
384
39
To Next Page
Loading...
