Avaya IP500 V2 - BRI Port (To)

IP500/IP500 V2 Installation Page 380
15-601042 Issue 25i (03 January 2013)IP Office 8.0
9.16.5 BRI Port (To)
These ports are BRI To interface ports for connection to external BRI trunk services. Note that BRI ports found on the
IP400 So8 module are BRI-S interface ports for connect to ISDN terminal devices, see BRI Port (So) .
PRI/BRI Trunk Cable
This cable is used to connect from IP Office BRI/PRI trunk ports to the line providers network termination equipment. If
that equipment does not use RJ45 sockets, the cable may need to be stripped and rewired or an alternate cable used. The
appropriate signal pin-outs and wire colours are detailed below.
IP Office
Wire
Network
Termination
BRI
RJ45
BRI
PRI
PIN
RJ45
1
–
Rx-A
White/Orange
1
2
–
Rx-B
Orange/White
2
3
Tx-A
–
White/Green
3
4
Rx-A
Tx-A
Blue/White
4
5
Rx-B
Tx-B
White/Blue
5
6
Tx-B
–
Green/White
6
7
–
–
White/Brown
7
8
–
–
Brown/White
8
· Supply: BRI/PRI trunks cards are not supplied with these cables.
· Cable Color: Red.
· SAP Code: 700213440.
· Standard Length: 3m/9'10".
· Maximum Length: 5m/16'5''.
· Though not used pins 7 and 8 are through connected for ease of construction.
379