IP500/IP500 V2 Installation Page 68
15-601042 Issue 25i (03 January 2013)IP Office 8.0
3.1.3 Starting IP Office Manager
IP Office Manager is used to access all parts of the IP Office configuration.
Manager can also be used to upgrade the software files used by an IP Office
system.
Requirements
· o IP Office Administration PC
A Windows PC with the IP Office Administrator Application suite installed
.
· o LAN Cable
1.
Select Start | Programs | IP Office | Manager.
2.
If the PC has firewall software installed, you may be prompted as to whether you want to allow this program to
access the network. Select Yes or OK.
3.
Select File | Open Configuration from the menu bar.
4.
The Select IP Office window appears. After a few seconds it should list the IP Office control unit. The default name
used for a newly installed IP Office control unit is its MAC address.
· If the system required was not found, the address used for the search can be changed. Enter or select the
required address in the Unit/Broadcast Address field and then click Refresh to perform a new search.
5.
Click the check the box next to the system and then click OK.
6.
The name and password request is displayed. The name and password must match one of those setup through the
security settings. For a IP Office Essential Edition system, the default name and password for full configuration
settings access are Administrator and Administrator.
65
To Next Page
Loading...
