IP500/IP500 V2 Installation Page 78
15-601042 Issue 25i (03 January 2013)IP Office 8.0
4.4.3 Adding a Pre-Built Configuration File
IP Office Manager can be used to create an IP Office configuration file . For IP500v2 control units, such a pre-created
IP Office configuration file can be placed on the System SD card. That file will then be used when the IP Office system is
started.
1.
Using IP Office, create an offline configuration that matches the customer requirements and the equipment that will
be installed in the IP Office.
2.
Rename the configuration file config.cfg.
3.
Using a card reader, copy the file into the /system/primary folder on the System SD memory card.
77
To Next Page
Loading...
