These notes relate to the older design of wall mounting kit (SAP 70043015) used
for IP500 and IP500v2 control units. This kit cannot be used for external expansion
modules.
The kit includes two brackets, one top and one bottom, and screws for attachment
to the control unit. Additional 4 x 4.5mm fixtures and fittings are required suitable
for the wall type.
In addition to the existing environmental requirements for an IP Office system,
the following additional requirements apply when wall mounting a unit:
· The wall surface must be vertical, flat and vibration free. Attachment to
temporary walls is not supported.
· Only the screws provided with the mounting kit should used to attach the
brackets to the control unit.
· The brackets must be used as shown, with the deeper tray-like bracket used
at the bottom of the wall mounted control unit.
To Next Page
Loading...
