Avaya IP500 V2 - Starting the System

IP500/IP500 V2 Installation Page 94
15-601042 Issue 25i (03 January 2013)IP Office 8.0
4.11.1 Checking the LEDs
Control Unit LEDs
LED
Description
Optional SD
· Off = Card shutdown .
· Green on = Card present.
· Green flashing = Card in use.
· Orange steady = Reset imminent.
· Red flashing = Card initializing or shutting down.
· Red fast flashing = card full
· Red steady = Card failure/wrong type.
System SD
CPU
· Alternate red/green = Starting up.
· Green on = Okay.
· Red on = No software.
· Flashing Red = Error/Shutdown.
Base Card LEDs
Base Card
LEDs 1 to 8 Usage
All Cards
· LED1 is also used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
IP500 Analog Phone
· No status LEDs are used for analog phone extensions.
IP500 Digital Station
· Green On = Phone detected.
IP500 Combination
LEDs 1 to 6
· Green On = Phone detected.
IP500 VCM
· LEDs 1 to 8 are unlabelled. They are used to indicate voice compression channel usage.
Each LED lit represents 12.5% of the available voice compression channel capacity in
use (total card capacity rather than licensed capacity).
IP500 4-Port Expansion
LEDs 1 to 8 are used for the expansion ports on the rear of the control unit. LEDs 9 to 12
are used for the card's own expansion ports.
Green
On
Expansion module present.
Red
Flashing
Initializing.
Red
On
Error.
Orange
Regular Flash
Base card okay.
Trunk Daughter Card LEDs
Trunk Daughter Card
LEDs 9 to 12 Usage
All cards
· LED 9 is also used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
Analog Trunk
· Green on = Card fitted.
· Green flashing = Trunk in use.
PRI Trunk
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
· Red/Green Fast Flash (port 9) or Green Fast Flash (port 10) = Alarm indication
signal (AIS) from the trunk remote end.
· Red with Green Blink (port 9) or Green Blink (port 10) = Port in loopback mode (set
through IP Office System Monitor).
BRI Trunk
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
170