IP500/IP500 V2 Installation Page 97
15-601042 Issue 25i (03 January 2013)IP Office 8.0
IP500 V2 Installation: Changing the System to Standard Mode
4.12.2 Automating the Change to Standard Mode
If the only systems that you install are IP Office Essential Edition, the Manager application can be used to automate part of
the process above.
· ! WARNING
This process will require the IP Office system to reboot in order to complete the process. Any current calls and
services will be ended by the reboot.
1.
In IP Office Manager, select File | Preferences.
2.
On the Preferences sub-tab, enable Default to Standard Mode.
3.
With this option enabled, when a configuration for a new or defaulted system running in IP Office Basic Edition -
Quick Mode is received by Manager, it will automatically be converted to a IP Office Essential Edition configuration.
This setting does not affect existing systems with non-default configurations.
4.
! Important: IP Address Settings Default to Server
The conversion will set the DHCP mode to Server and the LAN addresses to their defaults of 192.168.42.1 and
192.168.43.1. Using Manager to change these settings to the required values.
5.
This is a suitable time to begin initial configuration before sending the configuration back to the IP Office system
to restart in IP Office Essential Edition.
· For IP Office Release 8.0 and higher, for an IP500v2 system to run in IP Office Essential Edition, its
configuration must include an Essential Edition license. A IP Office Essential Edition system without this
license will not allow any telephony functions.
6.
Sending the configuration back to the system will restart the system in IP Office Essential Edition.
102
To Next Page
Loading...
