© 2019 Avaya Inc. All rights reserved.
© 2015 Avaya Inc. All rights reserved. NDA Confidential, Use pursuant to your agreement.
detected by a nearby endpoint for acoustic pairing. A list of all the detected
endpoints will be displayed by the Screen Link Client, together with their status
(represented by icons). Detected endpoints are automatically wake up from
standby mode to display on their screen the title bar with their name and IP
address. Please note that the sonic detection is done through the embedded mics
of the Codec Units, when the CU app is running, even if a different USB or BT mic
is connected.
• Enter a Manual Location /Connect to Other Endpoint (Manual pairing): you can
manually select an endpoint in the Screen Link Client by its IP address. If the
endpoint is in stand-by mode, you need to wake up the endpoint using its remote-
control, to be able to see its IP address.
Equinox Client for Windows: Chose an Endpoint manually
Important
• Connectivity Requirements: A Screen Link client must be able to connect to
the Endpoint IP address for manual pairing, and the Endpoint must be able to
connect to the Screen Link client as a streaming server once paired. Please
assure that the PC/Mac’s firewall is not blocking the connection from the
endpoint to the computer (RTSP, port 554).
If not in a call, the shared content will be immediately displayed on the CU360 App (if Local
Presentation Mode is set to Automatic, otherwise press 'Present' button).
When in a call, the shared content will be immediately displayed on the unit and shared with
remote peers as presentation stream (if Remote Presentation Mode is set to Automatic, see
codec unit Configuration below. Otherwise a manual start (present button or key press) is
needed to start sharing).
Once the client is successfully paired to a selected endpoint, its icon on the tray bar might
change while XT will show below icon (white) on the title bar.
Icons on Codec Unit when Screen Link is active
Important
• When another client has an active Screen Link connection with the same unit,
the pairing will fail (the endpoint is listed with forbidden icon or manual pairing
will fail with "Endpoint unavailable" message).
• To activate Screen link from a different client, terminate presentation on the unit
by pressing Present or stop screen link from the client.
• You can also unpair the screen link client from the unit, manually or
automatically. See “Unpair Screen Link” section.
Important
• While a screen link is shared to a remote party, splitting the screen on the unit
to share an app will have no effect. You need to stop presentation before
splitting the screen.
To Next Page
Loading...
