Common UX Shortcuts
• To redial a call, long press with the mouse over the item in the list.
• To check the call status and diagnostics during a call, press the Stats button in the
Call Control Panel. To view statistics for each participant in a meeting, press left/right
arrows to select the previous and next participant.
• Access the Call Control Panel by pressing 'ok/menu' on the Remote-Control or click
with the mouse in the center of the page). The Panel automatically disappears after a
few seconds. To manually hide it, press the 'Home/Esc' key.
• When entering the meeting ID for a videoconference hosted by an Avaya
Equinox/Scopia MCU, use the * key on the keyboard to delete an incorrect digit (as
indicated on the visible prompt).
Remote Control Shortcuts
Your Avaya CU360 is pre-paired with its remote-control unit. If the remote-control unit is not pre-
paired, or you need to pair it with a different unit, follow below instructions.
To pair the remote control with your Avaya CU360, you need to do the following:
• Assure that the remote control is equipped with 2 AAA charged batteries.
• Unplug the codec unit from power.
• Press the Back key and the OK key together, until the small blue LED on top of the remote
quickly flashes a few times.
• While the LED light is still flashing, plug the codec unit into power while keeping the
remote control close to the unit. The remote control led should stop flashing to show
successful pair.
• If the pairing fails, assure to disconnect all the cables from the CU, including USB.
To Next Page
Loading...
