Remote Control Keys
Small Keyboard Keys – Press FN to switch between Yellow and White symbols
Once the remote control is paired with your Avaya CU360, the CU360 Video-collaboration
application will receive the key events when it is maximized and has the input focus. Some events
are managed even when the app is minimized or does not have the focus. Please note that if the
screen is split, the input focus must be assigned to the proper side of the screen by clicking on it.
You can use the following shortcuts:
• To show or hide a mouse pointer, press the ‘Mouse’ key.
• To exit from a CU360 App page or from an app, press the ‘Back’ key
• To Mute or Unmute the audio in your device, use the ‘Mute/Unmute’ key when the
CU360 Video-collaboration application has the focus.
• To Connect or Disconnect the call in your device, use the corresponding keys when
the CU360 Video-collaboration application has the focus.
• Short press the 'Power' key to put in standby (sleep mode) the system or to wake-up
the system (it could cause monitor off or monitor to automatically change channel, if
more inputs are connected to your monitor). While in a call, short pressing this key
has no effect
• Short press any key except mouse key to wake-up the system
• Long press the 'Power' key to switch on/off the system. To switch off the system, keep
the key pressed until you see the warning on the monitor that the system is powering
off.
• To switch between yellow and white symbols on the keyboard on the back of the
remote control, press the FN key.
To Next Page
Loading...
