– Click left button and drag to move
– Short click to emulate a click
– Long click to emulate a long click
– Right click to emulate ‘Back’
Remote Device Panel with move area (left) and scroll area (right)
Important
See Known Issue section for a limitation in this feature when using Web Browsers on iOS
mobile devices
Network Connectivity
Before configuring your device for the first time, assure that the device is connected to an Ethernet
or Wi-Fi network.
Please be aware that it is strongly suggested to NOT connect both Ethernet and Wi-Fi network,
except in special conditions (see Known Issues for Network).
Please note that an IP address is automatically assigned to the unit if you connect the unit to the
network using the Ethernet and your network is equipped with a DHCP server,
To connect the unit to the network using Wi-Fi, you need to select the proper Wi-Fi network in the
Android Settings and insert the credentials and the authentication type.
Wi-Fi and Bluetooth settings can be accessed in
[GUI] CONFIGURE>QUICK SETUP
[GUI] CONFIGURE > ADVANCED > [ADMINISTRATOR PIN] > SYSTEM>SECURITY>SETTINGS
Security Settings
To Next Page
Loading...
