Parameter Description
SIGNALING_ADDR_MODE Describes the SIP registration over IPv4 or IPv6
and selects the preferred Avaya Aura
®
Session
Manager for phones supporting the dual-stack
mode. The Avaya Aura
®
Session Manager IP
address is selected according to the parameter
SIP_CONTROLLER_LIST_2.
Valid values are:
• 4: IPv4. This is the default value.
• 6: IPv6
Shared control
With the shared control feature. the phones can be controlled from a soft phone client. The phone
needs to be registered before establishing a shared control connection. To operate shared control,
the value of SIP_CONTROLLER_LIST must be identical for the phone and the soft client.
Depending on soft client implementation, a shared control session may not be established if
multiple devices are registered to the same user at the same time, with the sc-enabled flag sent
during registration.
Note:
• SIP signaling must be set to TLS for the phone and the soft client. For security reasons,
TCP Signaling with shared control is not supported.
• The Avaya J139 IP Phone does not support Shared control feature.
Related links
Multiple Device Access on page 127
Microsoft Exchange Server integration
To integrate with Microsoft
®
Exchange Server, you need to configure the parameters in the
46xxsettings.txt file and set the required values in the Settings menu on the phone.
For more information about configuring the parameters via the phone menu, see the “Configuring
Microsoft
®
Exchange Server calendar” section in the using guide of the required phone model.
Configuring the settings file parameters
Set the following parameters in the 46xxsettings.txt file to specify your company email
domain, your company email user domain, and add trust certificates if required:
Microsoft Exchange Server integration
December 2018 Installing and Administering Avaya J100 Series IP Phones 129
Comments on this document? infodev@avaya.com
To Next Page
Loading...
