Avaya J100 - Page 161

Use the 46xxsettings.txt file to set the following parameters:
Parameter name Default Value Description
ENABLE_PRESENCE 1 Specifies whether presence is
supported.
The options are:
• 0: Disabled
• 1: Enabled
Note:
This parameter is set to 0 in
an IP Officeand in third-party
call control environment.
ALLOW_DND_SAC_LINK_CHAN
GE
0 Specifies whether to enable DND
and SAC link button on the menu.
The options are:
• 0: To disable DND and SAC link
button.
• 1: To enable DND and SAC link
button.
Note:
Only Avaya J169/J179 IP
Phone supports this feature.
DND_SAC_LINK 0 Specifies whether to enable DND
and SAC link button on the menu.
The value of this parameter is
used if the
ALLOW_DND_SAC_LINK_CHAN
GE is set to 0
The options are:
• 0: To enable DND, and not
SAC.
• 1: To enable DND and SAC.
Note:
Only Avaya J169/J179 IP
Phone supports this feature.
PRESENCE_ACL_CONFIRM 0 Specifies the handling of a
Presence ACL update with
pending watchers.
Table continues…
Presence
December 2018 Installing and Administering Avaya J100 Series IP Phones 161
Comments on this document? infodev@avaya.com