Avaya J100 - Page 27

Parameter Name Default Value Description
WIFISTAT parameter is enabled
and WLAN_SECURITY is set as
wpa2e.
The name must be from one to 32
characters.
Note that the space character and
ASCII 0x20 are not supported.
WLAN_WPA2E_ANONYMOUS_I
DENTITY
N/A Specifies the 802.1x anonymous
name of pre-configured Wi-Fi
network. This parameter is
applicable if WIFISTAT parameter
is enabled,
WLAN_WPA2E_EAP_METHOD
is set to PEAP and
WLAN_SECURITY is set as
wpa2e.
The name must be from one to 32
characters.
Note that the space character and
ASCII 0x20 are not supported.
WLAN_L2QUAD
6
Specifies the layer 2 priority value
for audio frames generated by the
telephone.
Valid value is from 0 to 7.
WLAN_DSCPAUD
46
Specifies the layer 3
Differentiated Services (DiffServ)
Code Point for audio frames
generated by the telephone.
Valid value is from 0 to 63.
WLAN_L2QSIG
3
Specifies the layer 3
Differentiated Services (DiffServ)
Code Point for audio frames
generated by the telephone.
Valid value is from 0 to 63.
SET WLAN_DSCPSIG
34
Specifies the layer 3
Differentiated Services (DiffServ)
Code Point for signaling frames
generated by the telephone.
Valid value is from 0 to 63.
Hardware setup
December 2018 Installing and Administering Avaya J100 Series IP Phones 27
Comments on this document? infodev@avaya.com