Avaya J100 - Configure Network Settings; Configure SIP Interface Settings

6
in the next section. For parameter description, see the Installing and Administering Avaya J129 IP Phone
in third-party call control setup for J129.
1.1.1 Configure Network Settings
Step
Command
Step 1
SET ENABLE_UDP_TRANSPORT 1
Step 2
SET DNSSRVR “8.8.8.8”
Step 3
SET DOMAIN “”
Step 4
SET SNTPSRVR pool.ntp.org
Step 5
SET SNTP_SYNC_INTERVAL 144000
1.1.2 Configure SIP Interface Settings
Step
Command
Step 1
SET SIPDOMAIN "3cx.hcm.com"
Step 2
SET SIP_CONTROLLER_LIST "3cx.hcm.com:5060;transport=tcp" (or udp,
tls)
Step 3
SET ENABLE_G711A 1
Step 4
SET ENABLE_G711U 1
Step 5
SET ENABLE_G722 1
Step 6
SET ENABLE_G726 0
Step 7
SET G726_PAYLOAD_TYPE 110
Step 8
SET ENABLE_G729 1
Step 9
SET ENABLE_OPUS 0
Step 10
SET SEND_DTMF_TYPE 2
Step 11
SET DTMF_PAYLOAD_TYPE 120
Step 12
SET 100REL_SUPPORT 1
Step 13
SET PLAY_TONE_UNTIL_RTP 1
Step 14
SET SYMMETRIC_RTP 1
Step 15
SET REGISTERWAIT 1200
Step 16
SET WAIT_FOR_UNREGISTRATION_TIMER 32
Step 17
SET WAIT_FOR_INVITE_RESPONSE_TIMEOUT 60
Step 18
SET FAILED_SESSION_REMOVAL_TIMER 30
Step 19
SET TCP_KEEP_ALIVE_STATUS 1
Step 20
SET TCP_KEEP_ALIVE_TIME 60
Step 21
SET TCP_KEEP_ALIVE_INTERVAL 10
Step 22
SET SIP_TIMER_T1 500
Step 23
SET SIP_TIMER_T2 4000