Avaya J100 - Bridged Appearance Buttons

When the user is not connected to a call, the button indicated as selected is the button that will be
used if the user goes off hook without pressing an appearance button. When a user is connected
to a call, that call is the selected button.
LED Red | Green Name Description
Off | Off Idle The call appearance is not in use and is not currently
selected.
On | Off Idle+Selected As above but this is the current selected button that will be
used if you go off hook.
Off | Flash Alerting Alerting for an incoming call, accompanied by ringing. If
already on a call, only a single ring is given.
On | Flash Alerting+Selected As above but this is the current selected button that
answered if you go off hook..
On | On In Use Here You have a currently connected call or are dialing.
Off | On In Use Elsewhere The call appearance button is in use on a bridged
appearance.
Off | Fast Flash On Hold Here You have put a call on hold.
Both Fast Flash On Hold Pending
Transfer
Off | Intermittent
Flash
On Hold Elsewhere A call on a bridged appearance button matched to the call
appearance has been put on hold.
Off | Broken
Flash
Invalid The button is not programmed for any function.
Related links
Appearance Buttons on page 20
Bridged Appearance Buttons
A bridged appearance button shows the state of one of another user's call appearance buttons. It
can be used to answer or join calls on that other user's call appearance button.
It can also be used to make a call that the call appearance user can then join or retrieve from hold.
This type of button is not supported on J139 phones.
• When the user's call appearance button alerts, your matching bridged appearance button
also alerts. The bridged appearance button can be used to answer the call on the call
appearance button user's behalf.
• When the call appearance button user answers or makes a call using that call appearance,
your matching bridged appearance button shows the status of that call, for example
connected, on hold, etc. The bridged appearance button can be used to retrieve the call if on
hold or to join the call if active.
• Bridged appearance buttons are not supported between users on different systems in a
network.
Introduction
April 2020 J100 Series Phone User Guide 22
Comments on this document? infodev@avaya.com