Avaya J129 - Page 103

Name Description
LLDP Specifies the status of LLDP.
The options are:
• Disabled
• Enabled
• Enabled- only if LLDP frame is received (default)
Ethernet Interface
Ethernet Specifies the speed and duplex settings for the Ethernet line interface.
The options are:
• Auto-negotiate (default)
• 10Mbps half-duplex
• 10Mbps full-duplex
• 100Mbps half-duplex
• 100Mbps full-duplex
PC Ethernet Specifies the speed and duplex settings for the secondary (PC)
Ethernet interface.
The options are:
• Disable
• Auto-negotiate (default)
• 10Mbps half-duplex
• 10Mbps full-duplex
• 100Mbps half-duplex
• 100Mbps full-duplex
PC Ethernet auto-MDIX Specifies the status of the auto-MDIX on PHY2.
The options are:
• Enable (default)
• Disable
Related links
Configuring Ethernet settings on page 98
Configuring Wi-Fi settings
About this task
Avaya J100 Series IP Phones display the details of the configuration fields in the Description
section of the screen.
Phone configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 103
Comments on this document? infodev@avaya.com