• Avaya J169 IP Phone supports three JBM24 Button Modules or two Avaya J100
Expansion Modules on PoE. For additional button modules, use 5V DC power adapter.
• Avaya J179 IP Phone supports two JBM24 Button Modules or one Avaya J100
Expansion Module on PoE. For additional button modules, use 5V DC power adapter.
Note:
The simultaneous connection of JBM24 Button Module and Avaya J100 Expansion
Module is not supported.
• If you are using a power adapter, disable PoE on the Ethernet connection.
The following table provides the power measurement of the phones, adjuncts, and peripherals.
Phone model Avaya standard power measurements (in Watts) Energy Star (in
Watts)
Conservation Typical Maximum Stand by
J129 2.20 2.73 3.45 1.04
J139 1.40 1.67 2.24 1.55
J169 1.72 1.84 2.34 1.85
J179 1.74 2.10 2.71 1.85
JBM24 0.19 0.69 1.35 NA
JEM24 1.70 1.90 2.00 NA
Wi-Fi/BT module NA NA 0.90 NA
The power requirements of the phone vary depending on the connected peripherals. The following
table provides the correlation between the connected peripherals and power requirements.
Phone model PoE Class
J129 • IEEE 802.3af PoE Class 1 without a wireless
module.
• IEEE 802.3af PoE Class 2 with a wireless
module.
J139 • IEEE 802.3af PoE, Class 1 device.
J169 • IEEE 802.3af PoE Class 1 without a button
module.
• IEEE 802.3af PoE Class 2 with a button module.
Table continues…
Avaya J100 Series IP Phones overview
July 2019 Installing and Administering Avaya J100 Series IP Phones 16
Comments on this document? infodev@avaya.com
To Next Page
Loading...
