5 (Optional) Attach the button module to the
phone.
Note:
JBM24 Button Module and Avaya
J100 Expansion Module are
supported only by Avaya J169/J179
IP Phone.
Button modules on page 13
6 Determine whether you are setting the
phone in an environment with Generic
configuration.
Phone installation process on page 27
7 Review prerequisite information and
gather the pre-configuration data.
8 Set up the provisioning server.
9 Connect Avaya J100 Series IP Phones to
the power supply and network with the
Ethernet cable.
Power specifications on page 15
10 Perform the installation following the tasks
for one of the selected methods.
Installing the wireless module
Before you begin
Obtain the following items:
• Phillips #1 screw driver to install the screw of the Avaya J100 Wireless Module.
• A flat screw driver that fits in the opening of the module panel.
Procedure
1. Insert the screw driver in the opening of the module panel to release the latch. Do not pry
open the panel.
Initial setup and connectivity
July 2019 Installing and Administering Avaya J100 Series IP Phones 20
Comments on this document? infodev@avaya.com
To Next Page
Loading...
