Avaya J129 - Page 209

Parameter name Default value Description System Manager
parameter name
RECOVERYREGISTERW
AIT
60 Specifies the number of
seconds. If no response is
received by
WAIT_FOR_REGISTRATION_T
IMER to a REGISTER request
within the specified number of
seconds, the phone tries again
after a randomly selected delay
of 50% to 90% of the value of
RECOVERYREGISTERWAIT.
Valid values are from 10 to
36000.
Reactive Monitoring
REGISTERWAIT 900 Specifies the number of
seconds for next re-registration
to the SIP proxy.
Valid values are from 30 to
86400 seconds.
Registration Expiry
Timer
The value set in System
Manager overwrites the
value in
the46xxsettings.txt
file.
WAIT_FOR_REGISTRATI
ON_TIMER
32 Specifies the number of
seconds the phone will wait for
a response to a REGISTER
request. If no response
message is received within this
time, the phone tries to register
again based on the value of
RECOVERYREGISTERWAIT.
Valid values are from 4 to 3600.
NA
SIP_CONTROLLER_LIST Null Specifies a list of SIP controller
designators, separated by
commas without any intervening
spaces. When this parameter
has multiple IP addresses, the
list order defines the priority of
the controllers for selection
during a failover. The first
element of the list has the
highest priority, and the last
element has the lowest priority.
Primary Session
Manager, Secondary
Session Manager and
Survivability server
Table continues…
Parameters for redundancy provisioning
July 2019 Installing and Administering Avaya J100 Series IP Phones 209
Comments on this document? infodev@avaya.com