Wireless Module configuration
You can configure a Wi-Fi network by:
• Setting Wi-Fi parameters in the 46xxsettings.txt file
• Configuring Wi-Fi parameters through the phone UI
• Configuring Wi-Fi parameters through the web UI
Note:
• VLAN and LLDP functionalities are not supported over a wireless network.
• The Bluetooth functionality is not supported in the IP Office environment.
Wall mounting the phone
About this task
The wall mounting procedure for all Avaya J100 Series IP Phones is similar. Wall mounting
brackets look different for Avaya J169/J179 IP Phone.
You can order the wall mounting kit separately, using the part numbers that correspond to the
phone model. For example, the part number of the wall mount bracket is 700512707. The
procedure describes the wall mounting procedure with illustrations as reference.
The following procedure describes Avaya J100 Series IP Phones wall mounting with typical
illustrations provided as a reference.
Before you begin
Obtain the following items:
• Wall mounting kit that contains a wall mount bracket, and an Ethernet cable.
• Four #8 screws. The screws are not provided with the wall mounting kit.
Procedure
1. Do one of the following:
• Place the bracket on the wall, drill holes, and then affix the #8 screws.
Wireless Module configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 23
Comments on this document? infodev@avaya.com
To Next Page
Loading...
